Lenze EVS93xx CrossCutter - Manual (Page 127)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-113
The main CamDesigner window will now display the master axis (Line Speed Encoder) and the profile axis
(cross-cutter axis = CrossCutter):
The motion profile characteristic is defined and converted into an interpolation point table in the input window.
However, if you are using the CrossCutterMotionProfileCalculation function block, the definitive format of the
motion profile will not be defined until runtime of the PLC program, although CamDesigner is required at this
point to define the number of interpolation points and decimal positions for the Y-cycle (see next step).
Step 6