Lenze EVS93xx CrossCutter - Manual (Page 144)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-130
You now need to make the settings for the positioning parameters (Short Setup Positioning):
TIP!
See Chapter 2.5.7 for more information about positioning.
Make the following code settings:
C3620/001 Positioning: Deceleration time (abort)
C3620/002 Positioning: Acceleration time
C3620/003 Positioning: Deceleration time
C3621/001 Positioning: Positive traversing speed
C3621/002 Positioning: Negative traversing speed
C3628/000 Target position (positioning mode)
C3629/000 Positioning mode
Step 8