Lenze EVS93xx CrossCutter - Manual (Page 213)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-45
Possible settings: Code
Default Selection
Comment
C3681/
000
0 -15000... {1 rpm} ...15000
Selection of the test signal for the simulation of the DFIN input
C3683/
000
15000 -15000... {1 rpm} ...15000
Selection of speed limitation, upper speed limit
C3684/
000
-15000 0 ... {1 rpm} ...15000
Selection of speed limitation, lower speed limit
C3685/
000
- - {1 [m_units/
min]}
-
Display code: Line speedt
C3686/
000
- - {1 [m_units/
min]}
- Display code: Maximum possible line speed for set synchronus
cutting length.
C3687
000
- - {1 [m_units/
min]}
-
Display code: Maximum possible line speed for set reject length.
C3688/
000
- - {1 [m_units/
min]}
-
Display code: Maximum possible line speed for set test length.
C3689/
000
- - {1 [m_units/
min]}
- Display code: Maximum possible line speed for set start/stop
length.
C3690/
000
- - {1} - Display code: Number of knives mounted on the knife drum. Up to
6 knives can be mounted on the knife drum.
Selection of calculation method for asynchronous section of
motion profile
0 Second order polynomial (linear speed ramps)
1 Fifth order polynomial
C3691/
000
1 0 {1} 2
2
Sloping sine line
Display code: Status of calculation sequence for new asyn.
cutting length
0 Calculation ok.
1 • No LC9 file found.
• Profile data not found in absolute data model.
• Read error when accessing profile data.
2 Selected motion profile not found.
4 The angle of motion of the knife drum for the
asynchronous motion phase is less than or equal to zero
(check y final value of basic profile and cutting angle!).
8 A value of zero has been entered for the knife drum's
cutting circle circumference.
16 The preset cutting length is less than the material length
corresponding to the cutting angle.
32 The selected motion profile contains fewer than 20
interpolation points.
64 The selected motion profile does not start at zero
(0.0000/0.0000).
128 Cutting angle too small.
256 The y final value of the basic profile does not correspond
to value 360.0000[°]/n
cuts/rev
.
(n
cuts/rev
= Number of knives on knife drum, values of 1, 2,
3, 4, 5 or 6 are possible)
512 Error during internal read access to C0011/000
C3692/
000
- - {1} -
If the status variable is exhibiting non-zero values, the calculated
variables may exhibit invalid values, in which case it will not be
possible to use them subsequently in the control program!
C3693/
000
- - {1 [m_units/
min]}
- Display code: Maximum possible line speed for set asynchronus
cutting length.
C3694/
000
- - {1[s_units]} -
Display code: Starting position of the cross cutter.
Display code: Cutting length induces start/stop operation of cross
cutter.
TRUE
The selected cutting length exceeds the
limit cutting length for start/stop operation
=> The pause will be extended accordingly
in the asynchronous motion phase.
C3700/
000
0 0 {1} 1
FALSE The selected cutting length undershoots the
limit cutting length for start/stop operation.