Lenze EVS93xx CrossCutter - Manual (Page 260)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-92
Variable Value/Meaning
Name Data type Value/Meaning
ARRAY OF DINT Variable for acceleration ramp for positioning when using variables
dnSetPositionTrimming_p and bLoadSetPositionTrimming. The ramp assumes
4000 rpm.
Possible settings
Default Selection
xxx.L_CamPosCtrlLin1.adnTiPos[2]
1.000 s 0.010 {0.001 s} 130.000
ARRAY OF DINT Variable for deceleration ramp for positioning when using variables
dnSetPositionTrimming_p and bLoadSetPositionTrimming. The ramp assumes
4000 rpm.
Possible settings
Default Selection
xxx.L_CamPosCtrlLin1.adnTiPos[3]
1.000 s 0.010 {0.001 s} 130.000
ARRAY OF INT Variable for forward motion (positive speed) for positioning when using variables
dnSetPositionTrimming_p and bLoadSetPositionTrimming.
Possible settings
Default Selection
xxx.L_CamPosCtrlLin1.anSpeed[1]
200 rpm -15000 {1 rpm} 15000
ARRAY OF INT Variable for return motion (negative speed) for positioning when using variables
dnSetPositionTrimming_p and bLoadSetPositionTrimming.
Possible settings
Default Selection
xxx.L_CamPosCtrlLin1.anSpeed[2]
200 rpm -15000 {1 rpm} 15000
* xxx stands for the instance name of the block.
User-specific codes can be created starting at value C3000. 7 codes must be created for each
function block call.