Lenze EVS93xx CrossCutter - Manual (Page 52)

Cross Cutter
Features of the "Cross Cutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 2-38
Possible settings: Code
Default Selection
Comment
Reject length induces start/stop operation of cross cutter.
TRUE
The selected reject length exceeds the limit
cutting length for start/stop operation =>
The pause will be extended accordingly in
the asynchronous motion phase.
C3701/
000
- - {1} -
FALSE The selected reject length undershoots the
limit cutting length for start/stop operation.
Test length induces start/stop operation of cross cutter.
TRUE
The selected test length exceeds the limit
cutting length for start/stop operation =>
The pause will be extended accordingly in
the asynchronous motion phase.
C3702/
000
- - {1} -
FALSE The selected test length undershoots the
limit cutting length for start/stop operation.
Start/stop length induces start/stop operation of cross cutter.
TRUE
The selected start/stop length exceeds the
limit cutting length for start/stop operation
=> The pause will be extended accordingly
in the asynchronous motion phase.
C3703/
000
- - {1} -
FALSE The selected start/stop length undershoots
the limit cutting length for start/stop
operation.
Application control word bit 11: Reset cutting counter for cutting
operation.
TRUE Reset counter.
C4135/
000
Bit 11
0 0 {1} 1
FALSE Counter will not be reset.
Application control word bit 12: Reset cutting counter for reject
operation.
TRUE Reset counter.
C4135/
000
Bit 12
0 0 {1} 1
FALSE Counter will not be reset.
Application control word bit 13: Reset cutting counter for test
operation.
TRUE Reset counter.
C4135/
000
Bit 13
0 0 {1} 1
FALSE Counter will not be reset.
Application control word bit 14: Start and stop selected cross-
cutter operating mode.
TRUE Start operation.
C4135/
000
Bit 14
0 0 {1} 1
FALSE Stop operation.
Application control word bit 15: Activate to immediately apply a
new cutting length you have calculated and work with the new
cutting length.
TRUE Apply new cutting length calculated.
C4135/
000
Bit 15
0 0 {1} 1
FALSE Do not apply new cutting length calculated, continue
to work with the last cutting length calculated.