Lenze EVS93xx CrossCutter - Manual (Page 152)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-138
You now need to set the parameters for the test profile (Short Setup Cross Cutting Operation
Settings Test Profile):
Make the following code settings:
C3657/000 Cutting length test arc
Enter the setpoint length of the test arc here.
The value is entered in [m_units].

Caution!
Entering a cutting length of 0 is impermissible and will lead to an error when calculating the
motion profile!
TIP!
See Chapter 2.5.1 for more information about test operation.
Step 4