Lenze EVS93xx CrossCutter - Manual (Page 146)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-132
Now make the parameter settings for X trimming
(Short Setup Cross Cutting Operation Cutting Trimming):
TIP!
See Chapter 2.5.11 for more information about X trimming.
Make the following code settings:
C3672/002 X trimming: Acceleration ramp position trimming
C3672/003 X trimming: Deceleration ramp position trimming
C3673/001 X trimming: Positive positioning speed
C3673/002 X trimming: Negative positioning speed
C3674/000 X trimming: Selection of trimming position
C3676/000 X trimming: Acceleration ramp time inching trimming
C3677/000 X trimming: Deceleration ramp time inching trimming
C3678/000 X trimming: Inching speed
Step 10