Lenze EVS93xx CrossCutter - Manual (Page 41)

Cross Cutter
Features of the "Cross Cutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 2-27
Outputs
Global variables (Variable type: VAR_GLOBAL)
Name Data type Value/Meaning
g_nNumberOfKnives INT Number of knives mounted on the knife drum.
This value is displayed in code C3690/000.
Status signal: Cutting length induces start/stop operation of cross cutter.
This value is displayed in code C3700/000.
TRUE
The selected cutting length exceeds the
limit cutting length for start/stop
operation => The pause will be extended
accordingly in the asynchronous motion
phase.
g_bStartStopOperationCuttingProfile
BOOL
FALSE The selected cutting length undershoots
the limit cutting length for start/stop
operation. (See Chapter 2.2.2
Synchronous cross cutter.)
Status signal: Reject length induces start/stop operation of cross cutter.
This value is displayed in code C3701/000.
TRUE
The selected reject length exceeds the
limit cutting length for start/stop
operation => The pause will be extended
accordingly in the asynchronous motion
phase.
g_bStartStopOperationRejectProfile BOOL
FALSE The selected reject length undershoots
the limit cutting length for start/stop
operation. (See Chapter 2.2.2
Synchronous cross cutter.)
Status signal: Test length induces start/stop operation of cross cutter.
This value is displayed in code C3702/000.
TRUE
The selected test length exceeds the
limit cutting length for start/stop
operation => The pause will be extended
accordingly in the asynchronous motion
phase.
g_bStartStopOperationTestProfile BOOL
FALSE The selected test length undershoots the
limit cutting length for start/stop
operation. (See Chapter 2.2.2
Synchronous cross cutter.)
Status signal: Start/stop length induces start/stop operation of cross cutter.
This value is displayed in code C3703/000.
TRUE
The selected start/stop length exceeds
the limit cutting length for start/stop
operation => The pause will be extended
accordingly in the asynchronous motion
phase.
g_bStartStopOperationStartStopProfile BOOL
FALSE The selected start/stop length
undershoots the limit cutting length for
start/stop operation. (See Chapter 2.2.2
Synchronous cross cutter.)