Lenze EVS93xx CrossCutter - Manual (Page 158)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-144
Continue by making the settings for the reject profile (Short Setup Cross Cutting Operation Settings
Reject Profile):
Make the following code settings:
C3656/000 Reject length
Enter the setpoint length here to be cut when reject operation
is selected. The value is entered in [m_units].
 Caution!
Entering a cutting length of 0 is impermissible and will lead to an error when calculating the
motion profile!
TIP!
See Chapter 2.5.1 and Chapter 2.5.12 for more information about reject operation.
Step 3