Lenze EVS93xx CrossCutter - Manual (Page 25)

Cross Cutter
Features of the "Cross Cutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 2-11
Are the combinatorial options sufficient for your application case?
Various combinatorial options can be considered for the use of the cross cutter depending
on the application.
1. Length-controlled operation: In this operating mode the material to be cut has no
print marks and the required cutting length is determined solely by the calculated
motion profile. In this operating mode, the cross cutter can be changed over when idle
and during operation.
2. Mark-controlled operation, without print-mark suppression: In this operating
mode the cross cutter works with mark control and higher-level length control. A mark
is made on the material wherever a cut needs to be made. In this operating mode, the
cross cutter can be changed over when idle and during operation.
?
NO
YES
Your application scenario
cannot be solved using the
prepared solution at this
time because the solution
does not support mark-
controlled operation, with
multiple cuts between two
print marks and
simultaneous
print-mark
suppression.