Lenze EVS93xx CrossCutter - Manual (Page 157)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-143
Now set the parameters for the cutting profile (Short Setup Cross Cutting Operation
Settings Cutting Profile):
Make the following code settings:
C3655/000 Setpoint cutting length
Enter the setpoint length here at which you wish the continuous material to be processed.
The value is entered in [m_units].
 Caution!
Entering a cutting length of 0 is impermissible and will lead to an error when calculating the
motion profile!
TIP!
See Chapter 2.5.1 and Chapter 2.5.8 for more information.
 Caution!
You are not permitted to change the setpoint cutting length during mark-controlled
operation because the cutting length is usually equivalent to the print-mark distance or the
print-mark distance is a multiple of the cutting length.
Step 2