Cross cutter – Lenze EVS93xx CrossCutter User Manual
Page 154
Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
Prepared Solution Servo PLC / ECSxA 1.1 EN
3-140
You now need to switch to the application control word (Short Setup Control/Status Interface Control
Interface):
Select the operating mode you wish to use in code C4137/000:
1 Cutting
mode
2 Reject mode
3 Test
mode
4 Asynchr.
mode
TIP!
•
You can switch between operating modes 1 to 3 even during cross-cutter
operation.
•
You cannot switch from one of operating modes 1 to 3 to operating mode 4
during operation. In order to switch modes, the system must be in standby
(C3505/000=Standby(10)).
•
You cannot switch from operating mode 4 to one of operating modes 1 to 3
during operation. In order to switch modes, the system must be in standby
(C3505/000=Standby(10)).
Step 6