Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 131)

Rockwell Automation Publication 290D-UM001A-EN-P - June 2012 131
Bulletin 290D/291D/294D Programmable Parameters Chapter 4
Motor and Control Group
SnapShotOutVolts
This parameter provides a snapshot
of output voltage at time of last trip.
Parameter Number 25
Access Rule GET
Data Type UINT
Group Trip Status
Units x.x V AC
Minimum Value 0
Maximum Value 999.9
Default Value 0
SnapShotBusVolts
This parameter provides a snapshot of DC
bus voltage level at time of last trip.
Parameter Number 26
Access Rule GET
Data Type UINT
Group Trip Status
Units V DC
Minimum Value 0
Maximum Value 1200
Default Value 0
SnapShotDrvTemp
This parameter provides a snapshot of
operating temperature at time of last trip.
Parameter Number 27
Access Rule GET
Data Type UINT
Group Trip Status
Units °C
Minimum Value 0
Maximum Value 9999
Default Value 0
MotorNPVolts
Set to the motor nameplate rated voltage.
Parameter Number 28
Access Rule GET/SET
Data Type UINT
Group Motor and Control
Units V AC
Minimum Value 35
Maximum Value 460
Default Value 460
O Stop drive before changing this
parameter.