Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 93)

Rockwell Automation Publication 290D-UM001A-EN-P - June 2012 93
Bulletin 290D/291D/294D Programmable Parameters Chapter 4
Trip Status Group
Bit
Function:
7 6 5 4 3 2 1 0
— — — X — — — — Out02
— — X — — — — — Out03
— X — — — — — — Out04
X — — — — — — — Out05
OutputSourceV (IPS)
[SwitchedVolts]
This parameter determines the incoming
switched control voltage across terminals
A1…A2.
(IPS) Available voltage on User Output Pin
4 for all I/O points
Parameter Number 11
Access Rule GET
Data Type UINT
Group Basic Status
Units x.xx Volts
Minimum Value 0
Maximum Value 65535
Default Value 0
SensorSourceV (IPS)
[UnswitchedVolts]
This parameter determines the incoming
unswitched control voltage across
terminals A2…A3.
(IPS) Available voltage on Input Sensor
Source Pin 1 for all I/O points
Parameter Number 12
Access Rule GET
Data Type UINT
Group Basic Status
Units x.xx Volts
Minimum Value 0
Maximum Value 65535
Default Value 0
TripStatus
This parameter provides the fault
condition that caused any current trip.
Parameter Number 16
Access Rule GET
Data Type WORD
Group Trip Status
Units —
Minimum Value 0
Maximum Value 0xE3BF
Default Value 0