Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 238)

238 Rockwell Automation Publication 290D-UM001A-EN-P - June 2012
Appendix B CIP Information
ZIP Object CLASS CODE 0x032E
The following class attributes will be supported.
ZIP Enable
Allows ZIP functionality to be enabled/disabled for the entire device. This
parameter must be disabled before any changes to the ZIP configuration for the
device can be made. The default value for this attribute is 0=disable. Upon
enabling ZIP, the ZIP object checks that the produced and consumed assembly
instances chosen for each ZIP producing and consuming connection contain the
Zone Key (instance attribute #7). If any of the chosen assemblies does not
contain the Zone Key in the last 2 bytes of the assembly data attribute, then the
error code 0x0C (Object State Conflict) is returned by the Set service.
Five Instances of the ZIP object will be supported. Instances 1-4 are ZIP
consumers, and Instance 5 is the ZIP producer.
Attribute ID Access Rule NV Name Data Type Description of Attribute Semantics of Values
1 Get NV Revision UINT 1
3 Get NV Number of Instances UINT 5
8 Get V Instance List Array of USINT List of instances A maximum of 255 instances may be supported.
9 Set NV ZIP Enable BOOL Enable/Disable ZIP for the device 0=disable 1=enable
Attribute ID Access Rule NV Name Data Type Description of Attribute Semantics of Values
1 Set* NV Zone Connection ID UDINT
The Connection ID *For producing connections,
Set access not required.
2 Get NV Zone Health BOOL
Health status of the connection 0=healthy
1=not healthy
3
Set*
(Get for
producers)
NV Zone Point Mask
STRUCT of:
USINT
Array of
BYTE
Masks individual bytes in a
consumed message for use
by in Zone Point Data table.
Masking results in a byte packed
image. Struct of
USINT = 4
Array[4] of BYTE
Producers return USINT= 0
4 Set* NV Zone Point Offset UINT
Specifies an offset into the 8-
byte Zone Point Data table to
place masked data. *Get access for producers.
Producers return UINT = 0
5 Set NV Zone RPI UINT
Requested Packet Interval
(RPI) of the producing or
consuming connection. This
value is placed in the Expected
Packet Rate attribute of the
connection ms
6 Set NV Zone PIT UINT
Production Inhibit Time (PIT)
of producing connection object ms
Required for I/O client connections, except those
with production trigger of Cyclic.
7 Get/Set* NV Zone Key UINT
The security key attribute for
the connection. *Access Rule of Get only for producing
connections.