Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 247)

Rockwell Automation Publication 290E-UM001B-EN-P - June 2012 247
Using DeviceLogix™ Appendix C
2. Click on the “DeviceLogix” tab. If you are on-line with a device, a dialog
box will appear asking you to upload or download. Click on “Upload.”
3. Click the “Start Logic Editor” button.
4. If programming off-line continue to step 5, otherwise click on the “Edit”
button. Click “Yes” when asked if you want to Enter Edit Mode. Once in
edit mode the entire list of Function Blocks will be displayed in the
toolbar.
5. Left Click on the “RSL” function block. This is a reset dominate latch.
6. Move the cursor into the grid, and left click to drop the function onto the
grid.
7. From the toolbar, Click on the “Discrete Input” button and select Pt00
from the pull-down menu. This is the remote start button based on the
example I/O table.
8. Place the input to the left of the RSL function. To drop the input on the
page, left click on the desired position.
9. Place the mouse cursor over the tip of Pt00. The tip will turn green. Click
on the tip when it turns green.
10. Move the mouse cursor toward the input of the RSL function. A line will
follow the cursor. When a connection can be made, the tip of the RSL
function will also turn green. Click the on Input and the line will be drawn
from Pt00 to the Set Input of the RSL function.
Note: If this was not a valid connection, one of the pin tips would have turned
red rather than green. Left double clicking on the unused portion of the grid or
pressing the “Esc” key at any time will cancel the connection process.