Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 236)

236 Rockwell Automation Publication 290D-UM001A-EN-P - June 2012
Appendix B CIP Information
DeviceNet Interface Object CLASS CODE 0x00B4
The following class attributes will be supported.
4 Warning 4 —
5 Warning 5 Indicates missing supply phase. This fault can be disabled.
6 Jam Warning Motor current has exceeded jam warning level.
7 Underload Warning Motor current dropped below Underload Warning level.
8 Warning 8 —
9 Warning 9 —
10 Warning 10 —
11 Warning 11 —
12 Warning 12 —
13 Switched Pwr Warn Indicates the control power has dipped below 19 Volts.
Not available in units with Integrated Power Supply.
14 Under Power Warn Indicates the internal power supply is below its optimal level.
Available in units with Integrated Power Supply only.
15 Warning 15 —
16 Warning 16 —
17 Warning 17 —
18 Warning 18 —
19 Warning 19 —
20 Warning 20 —
21 Aux Power Warn Indicates auxiliary Power was has dipped below 19 Volts.
Not available in units with Integrated Power Supply.
22 Warning 22
…
31 FanRPMWarning Internal fan is too slow, or needed to be kick started
…
41 BrakeConfig Values for params 58 - 63 and/or param 49 are invalid
42 IOPointConfig Values for params 58 - 63 and/or param 49 are invalid
43 ZIPConfig Values for params 114 - 129 result in ZIP data mapping overlap
44 JamConfig Param 72 JamTripLevel is less than Param 73 JamWarningLevel
45 UnderloadConfig Param 78 ULTripLevel is greater than Param 79 ULWarningLevel
…
75 Warning 75
Table 32 - Fault Codes, Fault Text, and Fault Help Strings for ArmorStart LT
Warning
Code Warning Text Help Text
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 2