Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 48)

48 Rockwell Automation Publication 290D-UM001A-EN-P - June 2012
Chapter 2 Installation and Wiring
ArmorConnect Power Media For greater flexibility and faster installations the user may also use
ArmorConnect media for a complete plug-n-play solution. This solution
provides plug-in style stop stations, as shown in
Figure 18 . The ArmorConnect
power media offers both three-phase and control power cable cord set systems.
These include patchcords, receptacles, tees, reducers and accessories to be utilized
with the ArmorStart LT Distributed Motor Controller. This cable system allows
quick connections and reduced installation time by utilizing pre-manufactured
cable assemblies for more reliable connection of the three phase and
control power.
Figure 18 - Media Diagram
1. DeviceNet Trunk Cable - Patchcord trunk cable with integral female or male connector on each end (example 1485C-P*N5-M5)
2. DeviceNet Mini- T-Port Tap - T-ports are used for connecting drops to the trunk line (example 1485P-P1N5-MN5KM)
3. DeviceNet Drop Cable - Drop cables and patch cords are used to connect devices to the network (example 1485G-P*M5-Z5)
4. DeviceNet Receptacle - Recepatcles are used when connections present but required (example 1485A–CXN5–M5)
5. DeviceNet Terminator - Properly designed DeviceNet networks require terminating resistors (example 1485A–T1N5)
IMPORTANT When specifying power media for use with the ArmorStart LT Distributed
Motor Controllers (Bulletin 290D/291D and Bulletin 294D) use only
ArmorConnect power media. The use of any other power media
will void the UL Listing of the motor controller.
IMPORTANT A single channel Stop is pictured. It is necessary to perform a risk assessment
and determine specific application requirements.