Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual User Manual
Page 233
Rockwell Automation Publication 290D-UM001A-EN-P - June 2012
233
CIP Information
Appendix B
The table below lists Fault Codes, Fault Text, and Fault Help Strings for Drive
units.
30
Hardware Fault
This is a major fault which renders the unit inoperable.
31
Fault 31
—
32
Fault 32
—
33
Fault 33
—
34
Fault 34
—
35
Fault 35
—
36
Fault 36
—
37
Fault 37
—
38
Fault 38
—
39
Fault 39
—
40
Unknown Fault
—
41
BrakeOption
Brake Option hardware does not match parameter 92 setting.
42
KeypadOption
Keypad Option hardware does not match parameter 92 setting.
…
75
Fault 75
—
Table 31 - Fault Codes, Fault Text, and Fault Help Strings for Drive Units
Fault
Code
Fault Text
Help Text
PF4M
Fault
Code
1
Fault 1
—
2
User Defined
User defined trip has occurred.
3
Motor Overload
The load has drawn excessive current.
7
4
Drive Overload
150% load for 1 min. or 200% load for 3 sec. exceeded.
64
5
Phase U to Gnd
A Phase U to Ground fault detected between drive and motor.
38
6
Phase V to Gnd
A Phase V to Ground fault detected between drive and motor.
39
7
Phase W to Gnd
A Phase W to Ground fault detected between drive and motor.
40
8
Phase UV Short
Excessive current detected between phases U and V.
41
9
Phase UW Short
Excessive current detected between phases U and W.
42
10
Phase VW Short
Excessive current detected between phases V and W.
43
11
Ground Fault
A current path to earth ground at one or more output terminals.
13
12
Stall Trip
The drive is unable to accelerate the motor.
6
13
Switched Power
Indicates the loss of switched control power.
Not available in units with Integrated Power Supply
14
Under Power Trip
Indicates the internal power supply is below its working level.
Available in units with Integrated Power Supply only.
15
Sensor Short
Flags a miswired hardware input point.
16
Output Short
Flags a miswired hardware output point.
Table 30 - Fault Codes, Fault Text, and Fault Help Strings for DOL and Reversers
Fault
Code
Fault Text
Help Text