Rockwell Automation 294D ArmorStart LT Distributed Motor Controller DeviceNet Version - User Manual - Manual (Page 135)

Rockwell Automation Publication 290D-UM001A-EN-P - June 2012 135
Bulletin 290D/291D/294D Programmable Parameters Chapter 4
Starter Protection Group
JogAccelDecel
Sets the acceleration and deceleration
time when a jog command is issued.
Parameter Number 40
Related Parameters 39
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units x.x secs
Minimum Value 0.1
Maximum Value 600.0
Default Value 10.0
ProtFltResetMode
This parameter configures the Protection
Fault reset mode.
0 = Manual
1 = Automatic
Parameter Number 41
Access Rule GET/SET
Data Type BOOL
Group Starter Protection
Units —
Minimum Value 0
Maximum Value 1
Default Value 0
ProtectFltEnable
This parameter enables the Protection
Fault by setting the bit to 1.
Parameter Number 42
Access Rule GET/SET
Data Type WORD
Group Starter Protection
Units —
Minimum Value 0
Maximum Value 0xFFFF
Default Value 0xBFFF