Dell POWEREDGE M1000E - Manual (Page 153)

Configuring System Information 151
Management Method — Select from the dropdown box. The policy is restricted by the management
chosen.
Interface — Choose the check box for the interface if the policy should have a rule
based on the interface. Interface can be a physical interface, a LAG, or a VLAN.
Source IP Address — Select the Source IP Address check box if the policy should have a rule based on
the IP address of the client sending the management traffic. Fill in the source IP address and mask
details in the fields provided. Note that Mask can be given in two formats: either dotted IP format (for
example, 255.255.255.0) or prefix length (for example, 32)
Action — Choose the action to be performed when the rules selected above are matched. Use the
dropdown box and choose Permit or Deny to permit or deny access.
Rule Priority — Configure priorities to the rules. The rules are validated against the incoming
management request in the ascending order of their priorities. If a rule matches, action is performed
and rules below are ignored. For example, if you configure Source IP 10.10.10.10 with priority 1 to
Permit, and configure Source IP 10.10.10.10 with priority 2 to Deny, then access is permitted if the
profile is active, and the second rule is ignored.
5. Click Apply Changes.
The new access profile is added, and the device is updated.
Activating an Access Profile
1. Open the Access Profile page .
2. Check Set Access Profile Active.
3. Click Apply Changes.
The access profile is enabled for the device.
Adding Rules to an Access Profile
1. Open the Access Profile page .
The Access Profile field shows the profile to which rules are added when the Add An Access Profile
Rule page is displayed.
2. Click Add Rule.
The Add An Access Profile Rule page displays.