Dell POWEREDGE M1000E - Manual (Page 721)

Configuring IP Multicast 719
PIM-SM Interface Configuration
Use the PIM-SM Interface Configuration page to configure PIM-SM for an interface. PIM-SM must be
enabled on the PIM-SM Global Configuration page for this interface configuration page to display.
To display the page, click Multicast > PIM-SM > Interface Configuration in the tree view.
Figure 12-48. PIM-SM Interface Configuration
The PIM-SM Interface Configuration page contains the following fields:
• Interface — Select the interface for which data is to be displayed or configured. At least one routing
interface must exist in order to display or configure data.
• Mode — Select Enable or Disable from the drop-down menu to set the administrative status of PIM-
SM on this interface. The default is Disable.
• Hello Interval (secs) — Enter the time in seconds between the transmission of which PIM Hello
messages on this interface. The valid values are from 10 to 3600 secs. The default value is 30.
• CBSR Preference — Enter the preference value for the local interface as a candidate bootstrap router.
The value of -1 is used to indicate that the local interface is not a candidate BSR interface. The valid
values are from -1 to 255. The default value is 0.