Dell POWEREDGE M1000E - Manual (Page 614)

612 Configuring IPv6
The OSPFv3 Route Redistribution Configuration page contains the following fields:
• Source Protocol — Select the type of source routes to configure for redistribution by OSPF. Valid
values are Static and Connected.
• Metric — Sets the metric value to be used as the metric of redistributed routes. This field displays the
metric if the source was pre-configured and can be modified. Valid values are 0 to 16777214.
• Metric Type — Sets the OSPF metric type of redistributed routes.
• Tag — Sets the tag field in routes redistributed. This field displays the tag if the source was pre-
configured, otherwise 0 is displayed. Valid values are 0 to 4294967295.
• Redistribute — Enables or disables the redistribution for the selected source protocol. This field has to
be enabled in order to be able to configure any of the route redistribution attributes.
Configuring OSPFv3 Route Redistribution
1. Open the OSPFv3 Route Redistribution Configuration page.
2. Specify Create to set up a new configured source. Specify Connected or Static to modify an existing
configured source.
Figure 10-31. OSPFv3 Route Redistribution Configuration - Configured Source
3. Set up or modify the remaining fields as needed.
4. Click Apply Changes.
The selected route redistribution is configured for OSPFv3, and the device is updated.