Dell POWEREDGE M1000E User Manual
Page 511
Configuring Routing
509
• Host Routes Accept Mode — Select Enable or Disable from the drop-down menu. If you select
Enable, the router accepts host routes. The default is Enable.
• Global Route Changes — Displays the number of route changes made to the IP Route Database by
RIP. This does not include the refresh of a route's age.
•
Global Queries — Displays the number of responses sent to RIP queries from other systems.
•
Default Information Originate — Enable or Disable Default Route Advertise.
• Default Metric — Sets a default for the metric of redistributed routes.This field displays the default
metric if one has already been set, or blank if not configured earlier. Valid values are 1 to 15.
Configuring RIP
1. Open the RIP Configuration
page.
2. Enter data in the fields as needed.
3. Click Apply Changes when finished.
RIP is configured, and the device is updated.
Configuring RIP using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• Routing Information Protocol (RIP) Commands