Dell POWEREDGE M1000E - Manual (Page 527)

Configuring Routing 525
Route Entry Configuration
Use the Router Route Entry Configuration page to add new and configure router routes.
To display the page, click Routing > Router > Route Entry Configuration in the tree view.
Figure 9-37. Router Route Entry Configuration
The Router Route Entry Configuration page contains the following fields:
• Network Address — Specify the IP route prefix for the destination from the drop-down menu. In order
to create a route, a valid routing interface must exist and the next hop IP Address must be on the same
network as the routing interface. Routing interfaces are created on the IP Interface Configuration
page. Valid next hop IP Addresses can be viewed on the Route Table page.
• Subnet Mask — Also referred to as the subnet/network mask, this indicates the portion of the IP
interface address that identifies the attached network.
• Protocol — This field tells which protocol created the specified route. Possible values are:
–
Local
– Static
– Default
– OSPF Intra
– OSPF Inter