Dell POWEREDGE M1000E - Manual (Page 631)

Configuring Quality of Service 629
Match Attributes (IPv6)
Use the following fields to match IPv6 packets to a class. For other fields not listed here, see the
description in "Match Attributes (IPv4)" on page 627. Click the check box for each field to be used as a
criterion for a class, and enter data in the related field. You can have multiple match criteria in a class.
The logic is a Boolean “logical-and” for this criteria.
• Source IPv6 Prefix — Requires a packet’s source port IPv6 address to match the address listed here.
Enter the address in the format: aaaa:aaaa:aaaa:aaaa.
• Source IPv6 Prefix Length — Prefix Length can be entered in the range of 0-128.
• Destination IPv6 Prefix — Requires a packet’s destination port IPv6 address to match the address
listed here. Enter the address in the format: aaaa:aaaa:aaaa:aaaa.
• Destination IPv6 Prefix Length — Prefix Length can be entered in the range of 0 to 128.
• IPv6 Flow Label — Flow label is a 20-bit number that is unique to an IPv6 packet, used by end
stations to signify quality-of-service handling in routers. The flow label of the incoming packet must
match this value. Range is 0-1048575.
Service Type Criteria
Click to select one of the following three Match fields to use in matching packets to class criteria:
• IP DSCP — Matches the packet’s DSCP to the class criteria’s when selected. Either select the DSCP
type from the drop-down menu or enter a DSCP value to match. Valid range is 0-63.
• Match Every — Requires a packet to match every criterion when Match Every is checked.
Configuring Class Criteria with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands