Dell POWEREDGE M1000E - Manual (Page 512)

510 Configuring Routing
RIP Interface Summary
Use the RIP Interface Summary page to display RIP configuration status on an interface.
To display the page, click Routing > RIP > Interface Summary in the tree view.
Figure 9-29. RIP Interface Summary
The RIP Interface Summary page displays the following fields:
• Interface — The interface, such as the routing-enabled VLAN on which RIP is enabled.
• IP Address — The IP Address of the router interface.
•
Send Version — Specifies the RIP version to which RIP control packets sent from the interface
conform. The default is RIP-2. Possible values are:
–
RIP-1 — RIP version 1 packets are sent using broadcast.
– RIP-1c — RIP version 1 compatibility mode. RIP version 2 formatted packets are transmitted
using broadcast.
– RIP-2 — RIP version 2 packets are sent using multicast.
– None — RIP control packets are not transmitted.