Dell POWEREDGE M1000E - Manual (Page 286)

284 Configuring Switching Information
– Assign ACL Priority — Assigns the priority of this ACL. If more than one ACL is applied to an
interface, then the match criteria for the highest priority ACLs are checked first.
Assigning an ACL to an Interface
1. Open the ACL Bind Configuration page.
2. In the Interface field, specify the Unit and Port, LAG, or VLAN to configure.
3. Select the IP, IPv6, or MAC ACL in the Select an ACL field.
Note: Whenever an ACL is assigned on a port, LAG, or VLAN, flows from that ingress interface
that do not match the ACL are matched to the default rule, which is Drop unmatched packets.
4. Specify the priority in Assign ACL Priority.
5. Click Apply Changes.
The ACL is attached to the specified interface(s).
Removing an Interface from an ACL
1. Open the ACL Bind Configuration page.
2. Click Show All.
3. In the Interface field, specify the Unit and Port, LAG, or VLAN to view the ACL bindings for that
interface.
4. Select the Remove check box for one or more ACLs to remove.
5. Click Apply Changes.
The specified ACL(s) are removed from the interface.
Assigning ACL Membership Using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• ACL Commands