Dell POWEREDGE M1000E - Manual (Page 455)

Configuring Routing 453
ARP Create
Use the ARP Create page to add an entry to the Address Resolution Protocol table.
To display the page, click Routing > ARP > ARP Create in the tree view.
Figure 9-1. ARP Create
The ARP Create page contains the following fields:
• IP Address — Enter the IP address you want to add. It must be the IP address of a device on a subnet
attached to one of the switch's existing routing interfaces.
• MAC Address — The unicast MAC address of the device. Enter the address as six two-digit
hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
Adding an Entry to the ARP Table
1. Open the ARP Create page.
2. Specify the addresses to be associated.
3. Click Apply Changes.
The addresses are now in the ARP cache.