Dell POWEREDGE M1000E - Manual (Page 586)

584 Configuring IPv6
Displaying DHCPv6 Statistics using the CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• DHCPv6 Commands
OSPFv3
OSPFv3 is the Open Shortest Path First routing protocol for IPv6. It is similar to OSPFv2 in its concept
of a link state database, intra/inter area, and AS external routes and virtual links. It differs from its IPv4
counterpoint in a number of respects, including the following: peering is done through link-local
addresses; the protocol is link rather than network centric; and addressing semantics have been moved to
leaf LSAs, which eventually allow its use for both IPv4 and IPv6. Point to point links are also supported in
order to enable operation over tunnels.
It is possible to enable OSPF and OSPFv3 at the same time. OSPF works with IPv4 and OSPFv3 works
with IPv6.
The OSPFv3 menu page contains links to web pages that define and display OSPFv3 parameters and
data. To display this page, click IPv6 > OSPFv3 in the tree view.
Following are the web pages accessible from this menu page:
• OSPFv3 Configuration
• OSPFv3 Area Configuration
• OSPFv3 Stub Area Summary
• OSPFv3 Area Range Configuration
• OSPFv3 Interface Configuration
• OSPFv3 Interface Statistics
• OSPFv3 Neighbors
• OSPFv3 Neighbor Table
• OSPFv3 Link State Database
• OSPFv3 Virtual Link Configuration
• OSPFv3 Virtual Link Summary
• OSPFv3 Route Redistribution Configuration
• OSPFv3 Route Redistribution Summary