Dell POWEREDGE M1000E - Manual (Page 43)

Configuring Dell PowerConnect 41
Check Boxes
Defining Fields
User-defined fields can contain 1 – 159 characters, unless otherwise noted on the Dell OpenManage
Switch Administrator Web page.
All characters may be used except for the following:
• \
• /
• :
• *
• ?
• <
• >
• |
Accessing the Switch Through the CLI
The switch can be managed over a direct connection to the console port or through a Telnet connection.
If you are managing a stack, ensure the serial interface cable is attached to the Master switch of the stack.
Using the CLI is similar to entering commands on a Linux system. If access is through a Telnet
connection, ensure the device has an IP address defined and that the workstation used to access the
device is connected to the device prior to using CLI commands.
For information about configuring an initial IP Address, see "Configuration Overview."
Table 2-4. Check Boxes
Check Box Type Description
Add Hyperlink that takes you to a configuration page.
Remove Removes the selected item.
General selection To enable a configuration item, i.e., adjust sensitivity of log files, select
match criteria for diffserv, select ACL rule parameters.