Dell POWEREDGE M1000E - Manual (Page 485)

Configuring Routing 483
– Attempt — This state is only valid for neighbors attached to NBMA networks. It indicates that no
recent information has been received from the neighbor, but that an effort should be made to
contact the neighbor (sending the neighbor Hello packets at intervals of Hello Interval).
– Init — In this state, a Hello packet has recently been seen from the neighbor. However,
bidirectional communication has not yet been established with the neighbor (i.e., the router itself
did not appear in the neighbor's Hello packet). All neighbors in this state (or greater) are listed in
the Hello packets sent from the associated interface.
– 2-Way — In this state, communication between the two routers is bidirectional. This has been
assured by the operation of the Hello Protocol. This is the most advanced state short of beginning
adjacency establishment. The (Backup) Designated Router is selected from the set of neighbors in
state 2-Way or greater.
– Exchange Start — This is the first step in creating an adjacency between the two neighboring
routers. The goal of this step is to decide which router is the master, and to decide upon the initial
DD sequence number. Neighbor conversations in this state or greater are called adjacencies.
– Exchange — In this state, the router is describing its entire link state database by sending
Database Description packets to the neighbor. In this state, Link State Request Packets may also
be sent asking for the neighbor's more recent LSAs. All adjacencies in Exchange state or greater are
used by the flooding procedure. These adjacencies are fully capable of transmitting and receiving
all types of OSPF routing protocol packets.
– Loading — In this state, Link State Request packets are sent to the neighbor asking for the more
recent LSAs that have been discovered (but not yet received) in the Exchange state.
– Full — In this state, the neighboring routers are fully adjacent. These adjacencies appear in router-
LSAs and network-LSAs.
• Events — The number of times this neighbor relationship has changed state, or an error has occurred.
• Permanence — This variable displays the status of the entry. Dynamic and permanent see how the
neighbor became known.
• Hellos Suppressed — This indicates whether Hellos are being suppressed to the neighbor.
•
Retransmission Queue Length — The current length of the retransmission queue.
Displaying OSPF Neighbor Configuration
1. Open the OSPF Neighbor Configuration page.
2. Select the interface and the IP address to display.
The neighbor configuration displays.
Displaying OSPF Neighbor Configuration using the CLI Command
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• OSPF Commands