Dell POWEREDGE M1000E - Manual (Page 705)

Configuring IP Multicast 703
Configuring PIM-DM using the CLI Command
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• PIM-DM Commands
PIM-DM Global Status
Use the PIM-DM Global Status page to view the administrative status of PIM-DM or PIM-SM on the
switch.
To display the page, click IPv4 Multicast > PIM-DM > Global Status or IPv6 Multicast > PIM >
Global Status in the tree view.
Figure 12-35. PIM Global Status
The PIM Global Status page contains the following fields:
• PIM Protocol — Select PIM-DM or PIM-SM. Only one PIM protocol can be enabled on the switch at
a time. If you select PIM-SM, additional fields appear.
• Admin Mode — Displays the administrative status of the selected PIM protocol on the system.
•
Data Threshold Rate — If PIM-SM is selected as the protocol, shows the minimum source data rate in
Kbps above which the last-hop router switches to a source-specific shortest path tree.
• Register Threshold Rate — If PIM-SM is selected as the protocol, shows the minimum source data
rate in Kbps above which the Rendezvous Point router switches to a source-specific shortest path tree.
Viewing Global PIM Settings using the CLI Command
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• PIM-DM or PIM-SM Commands