Dell POWEREDGE M1000E - Manual (Page 339)

Configuring Switching Information 337
Removing a MAC - VLAN Entry
1. Open the Bind MAC to VLAN page.
2. Click Show All.
The MAC - VLAN Bind Table displays.
3. Check Remove for each entry to remove.
4. Click Apply Changes.
The entry/entries are removed, and the device is updated.
Binding MACs to VLANs Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• VLAN Commands
Bind IP Subnet to VLAN
An IP Subnet to VLAN mapping is defined by configuring an entry in the IP Subnet to VLAN table, an
entry is specified through a source IP address, network mask, and the desired VLAN ID. The IP Subnet
to VLAN configurations are shared across all ports of the switch. There can be up to 64 entries configured
in this table.
Use the Bind IP Subnet to VLAN page to assign an IP Subnet to a VLAN.
To display the Bind IP Subnet to VLAN page, click Switching > VLAN > Bind IP Subnet to VLAN in
the tree view.
Figure 7-60. Bind IP Subnet to VLAN