Dell POWEREDGE M1000E - Manual (Page 344)

342 Configuring Switching Information
Removing Multiple Protocols From the Protocol Group Table
1. Open the Protocol Group page.
2. Click Show All.
The Protocol Group Table displays.
Figure 7-64. Protocol Group Table
3. Check Remove for the protocol groups you want to remove.
4. Click Apply Changes.
The protocol is removed, and the device is updated.
Configuring Protocol Groups Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• VLAN Commands
GVRP Parameters
The GARP VLAN Registration Protocol provides a mechanism that allows networking switches to
dynamically register (and de-register) VLAN membership information with the MAC networking
switches attached to the same segment, and for that information to be disseminated across all
networking switches in the bridged LAN that support GVRP.
The operation of GVRP relies upon the services provided by the Generic Attribute Registration Protocol
(GARP). GVRP can create up to 1024 VLANs.
Use the GVRP Global Parameters page to enable GVRP globally. You can also enable GVRP on a per-
interface basis.
To display the GVRP Global Parameters page, click Switching > VLAN > GVRP Parameters in the tree
view.