Dell POWEREDGE M1000E - Manual (Page 651)

Configuring Quality of Service 649
The Auto VoIP Configuration page contains the following fields:
• Auto VoIP Mode — Enables or Disables Auto VoIP mode. The default is Disable.
•
Traffic Class —Displays the traffic class used for VoIP traffic.
Configuring Auto VoIP Using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands
Auto VoIP Interface Configuration
Use the Auto VoIP Interface Configuration page to configure the Auto VoIP settings for each interface.
To display the Auto VoIP Configuration page, click Quality of Service > Auto VoIP > Interface
Configuration in the navigation menu.
Figure 11-22. Auto VoIP Interface Configuration
The Auto VoIP Interface Configuration page contains the following fields:
• Interface — Lists the interfaces, Unit and Port or LAG, on which Auto VoIP can be configured.
•
Auto VoIP Mode — Use the mode setting to either Enable or Disable the Auto VoIP mode on the
selected interface. The default is Disable.
• Traffic Class —Displays the traffic class used for VoIP traffic.