Dell POWEREDGE M1000E - Manual (Page 305)

Configuring Switching Information 303
Removing a Static Address from the Static Address Table
1. Open the Static MAC Address page .
2. Click Show All to display the Static MAC Address Table.
3. Check the Remove check box for the address to be removed.
4. Click Apply Changes.
The static address is deleted, and the device is updated.
Configuring Static Address Parameters Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• Address Table Commands
Dynamic Address Table
The Dynamic Address Table page contains fields for querying information in the dynamic address table,
including the interface type, MAC addresses, VLAN, and table sorting key. Packets forwarded to an
address stored in the address table are forwarded directly to those ports.
The
Dynamic Address Table also contains information about the aging time before a dynamic MAC
address is removed from the table.
To display the Dynamic Address Table, click Switching > Address Tables > Dynamic Address Table in
the tree view.