Dell POWEREDGE M1000E User Manual
Page 435
Viewing Statistics and Remote Monitoring
433
• Multicast Packets Received — Displays number of good multicast packets received on the interface
since the switch was last refreshed.
• CRC & Align Errors — Displays number of CRC and Align errors that have occurred on the interface
since the switch was last refreshed.
•
Undersize Packets — Displays number of undersized packets (less than 64 octets) received on the
interface since the switch was last refreshed.
•
Oversize Packets — Displays number of oversized packets (over 1518 octets) received on the interface
since the switch was last refreshed.
• Fragments — Displays number of fragments (packets with less than 64 octets, excluding framing bits,
but including FCS octets) received on the interface since the switch was last refreshed.
•
Jabbers — Displays number of packets received that were more than 1,518 octets long and had a FCS
during the sampling session.
• Collisions — Displays number of collisions received on the interface since the switch was last
refreshed.
•
Frames of 64 Bytes — Displays number of 64-byte frames received on the interface since the switch
was last refreshed.
•
Frames of 65 to 127 Bytes — Displays number of 65- to127-byte frames received on the interface since
the switch was last refreshed.
• Frames of 128 to 255 Bytes — Displays number of 128- to 255-byte frames received on the interface
since the switch was last refreshed.
•
Frames of 256 to 511 Bytes — Displays number of 256- to 511-byte frames received on the interface
since the switch was last refreshed.
•
Frames of 512 to 1023 Bytes — Displays number of 512- to 1023-byte frames received on the interface
since the switch was last refreshed.
• Frames of 1024 to 1518 Bytes — Displays number of 1024- to 1518-byte frames received on the
interface since the switch was last refreshed.
Viewing Interface Statistics
1. Open the RMON Statistics Group page.
2. Select an interface in the Interface field.
Statistics for the selected interface display.
Viewing RMON Statistics Using the CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• RMON Commands