Dell POWEREDGE M1000E - Manual (Page 361)

Configuring Switching Information 359
Removing a Bridge Multicast Group
1. Open the Bridge Multicast Group page.
2. Select the
VLAN ID associated with the bridge multicast group to be removed from the drop-down
menu.
The
Bridge Multicast Address and the assigned ports/LAGs display.
3. Check the Remove check box.
4. Click Apply Changes.
The selected bridge multicast group is removed, and the device is updated.
Managing Multicast Service Members Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• Address Table Commands
Bridge Multicast Forward
Use the Bridge Multicast Forward page to enable attaching ports or LAGs to a switch that is attached to
a neighboring Multicast switch. Once IGMP Snooping is enabled, multicast packets are forwarded to the
appropriate port or VLAN.
To display the Bridge Multicast Forward page, click Switching > Multicast Support > Bridge
Multicast Forward in the tree view.
Figure 7-76. Bridge Multicast Forward
The Bridge Multicast Forward page contains the following field and two editable tables:
• VLAN ID — Selects the VLAN to be affected.