Dell POWEREDGE M1000E - Manual (Page 469)

Configuring Routing 467
Default Route Advertise
• Default Information Originate — Enable or Disable Default Route Advertise.
•
Always — Sets the router advertise 0.0.0.0/0.0.0.0 when set to True.
• Metric — Specifies the metric of the default route. The valid values are 1 to 16777214. Enter 0 to
unconfigure.
• Metric Type — Sets the metric type of the default route. Options are External Type 1 and External
Type 2. External Type 2 is the default.
Modifying an OSPF Configuration
1. Open the OSPF Configuration page.
2. Change values as needed.
3. Click Apply Changes.
Changes are saved, and the OSPF Interface is updated.
OSPF Configuration CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• OSPF Commands
Area Configuration
The OSPF Area Configuration page lets you create a Stub area configuration and NSSA once you’ve
enabled OSPF on an interface through Routing > OSPF > Interface Configuration. At least one router
must have OSPF enabled for this web page to display.
To display the page, click Routing > OSPF > Area Configuration in the tree view. If a Stub Area has
been created, the fields in the Stub Area Information are available. If a NSSA has been created, the fields
in the NSSA Area Information are available.