Dell POWEREDGE M1000E - Manual (Page 550)

548 Configuring Routing
Removing a Tunnel
1. Open the Tunnels Configuration page.
2. Specify the tunnel to remove in the Tunnel drop-down menu.
3. Click Delete Tunnel.
The tunnel is deleted, and the device is updated.
Configuring a Tunnel using CLI Commands
For information about the CLI command that performs this function, see the following chapter in the
CLI Reference Guide:
• Tunnel Interface Commands
Tunnels Summary
Use the Tunnels Summary page to display a summary of configured tunnels. To display the page, click
Routing > Tunnels > Summary in the tree view.
Figure 9-55. Tunnels Summary
The Tunnels Summary page contains the following fields:
• Tunnel ID — The Tunnel ID.
•
Tunnel Mode — The corresponding mode of the Tunnel.
• IPv6 Mode — Shows whether IPv6 is enabled on the tunnel.
•
Source — The corresponding Tunnel Source Address. In the case where an interface has been
configured both the interface and the address are displayed. If the source interface has no address
configured then nothing is displayed in place of the address.
• Destination — The corresponding Tunnel Destination Address.
• Tunnel ID — The Tunnel ID.