Dell POWEREDGE M1000E - Manual (Page 354)

352 Configuring Switching Information
– Source MAC, VLAN, EtherType, SourceModule and Port Id
– Destination MAC, VLAN, EtherType, SourceModule and Port Id
– Source IP and Source TCP/UDP Port (default)
– Destination IP and Destination TCP/UDP Port
– Source/Destination MAC, VLAN, EtherType, source MODID/port
– Source/Destination IP and source/destination TCP/UDP port
Configuring the LAG Hash
1. Open the LAG Hash Configuration page.
2. Select the LAG to configure and the hash algorithm to assign to the LAG.
3. Click Apply Changes.
The parameters are modified, and the device is updated.
Configuring the LAG Hash Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• Port Channel Commands
LAG Hash Summary
The LAG Hash Summary page lists the channels on the system and their assigned hash algorithm type.
To display the LAG Hash Summary page, click Switching > Link Aggregation > LAG Hash Summary
in the tree view.