Dell POWEREDGE M1000E - Manual (Page 563)

Configuring IPv6 561
• IPv6 Routing Operational Mode — Displays the operational state of an interface.
• Interface Maximum Transmit Unit — Specifies the maximum transmit unit on an interface. If the
value is 0 then this interface is not enabled for routing. It is not valid to set this value to 0 if routing is
enabled. The valid range of MTU is 1280 to 1500.
• Router Duplicate Address Detection Transmits — Specifies the number of duplicate address
detections transmits on an interface. DAD transmits values must be in the range of 0 to 600.
• Router Advertisement NS Interval — Specifies retransmission time field of router advertisement sent
from the interface. A value of 0 means the interval is not specified for this router. The range of
neighbor solicit interval is 1000 to 4294967295.
• Router Lifetime Interval — Specifies the router advertisement lifetime field sent from the interface.
This value must be greater than or equal to the maximum advertisement interval. 0 means do not use
the router as the default router. The range of router lifetime is 0 to 9000.
• Router Advertisement Reachable Time — Specifies the router advertisement time to consider
neighbor reachable after the neighbor discovery (ND) confirmation. The range of reachable time is 0
to 3600000.
• Router Advertisement Interval — Specifies the maximum time allowed between sending router
advertisements from the interface. The default value is 600. the range of maximum advertisement
interval is 4 to 1800.
• Router Advertisement Managed Config Flag — Specifies the router advertisement managed address
configuration flag. When true, the end nodes use DHCPv6. When false, the end nodes auto configure
the addresses. The default value of managed flag is Disable.
• Router Advertisement Other Config Flag — Specifies the router advertisement other stateful
configuration flag. The default value of other config flag is Disable.
• Router Advertisement Suppress Flag — Specifies the router advertisement suppression on an
interface. The default value of suppress flag is Disable.
• IPv6 Destination Unreachables — Indicates whether the interface sends (Enabled) or suppresses
(Disabled) ICMPv6 unreachable messages. This field also applies to tunnels.
Configuring IPv6 Interface
1. Open the IPv6 Interface Configuration page.
2. Modify the fields as needed.
3. Click Apply Changes.
The IPv6 interface modifications are saved, and the device is updated.
Configuring IPv6 Interface with the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• IPV6 Routing Commands