Dell POWEREDGE M1000E - Manual (Page 366)

364 Configuring Switching Information
Figure 7-79. Global Querier Configuration
The Global Querier Configuration page contains the following fields:
• IP Address— Specifies the Snooping Querier IP Address which will be used as the source address in
periodic IGMP queries. This address is used when no address is configured for the VLAN on which the
query is being sent.
• Snooping Querier Admin Mode — Enables or disables the administrative mode for IGMP Snooping
for the switch.
• IGMP Version — Specifies the version of IGMP protocol used in periodic IGMP queries.
• Query Interval (1–1800) — Specifies the time interval in seconds between periodic queries sent by the
Snooping Querier. The default value is 60.
• Expiry Interval (60–300) — Specifies the time interval in seconds after which the last querier
information is removed. The default value is 60.
Configuring IGMP Snooping Global Querier Settings with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• IGMP Snooping Commands