BendixKing KSN 770 - Pilots Guide - Manual (Page 163)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014 7-9
Charts View
Honeywell International Inc. Do not copy without express permission of Honeywell.
Current Aircraft (Ownship)
The pilot can overlay the Ownship symbol on airport
diagrams and instrument approach procedures.
When the OWN bezel softkey label is active, the
Ownship symbol is displayed. When the aircraft is
located within the valid display area of the airport
diagram or a geo--referenced instrument approach procedure with the
GPS track (greater than 30--knot groundspeed) or heading information
valid, the Ownship symbol is displayed and oriented appropriately.
When the heading input is not installed or if a heading
failure occurs, and the GPS track is not valid or less
than 30--knot groundspeed, the aircraft symbol is
removed from the display and only the cyan circle
remains. The cyan circle displays approximate GPS
location, however heading orientation is not given. When GPS track is
valid and the groundspeed is greater than 30 knots, the ownship symbol
is displayed regardless of not having a heading input or having a
heading failure.
NOTE: The plan--view portion of geo--referenced instrument
approach procedures can display the Ownship symbol. The
Ownship symbol display is limited to the to scale area of
terminal procedures. Most standard instrument departure
(SIDs), STARS, DPs, and ODPs are not to scale and
therefore cannot display the Ownship symbol.
CAUTION
OWNSHIP OVERLAY ON INSTRUMENT APPROACH
PROCEDURES IS INTENDED TO ENHANCE SITUATIONAL
AWARENESS ONLY AND IS NOT TO BE USED FOR
NAVIGATION.
Airport diagrams are specifically designed to assist in the movement of
ground traffic at locations with complex runway/taxiway configurations.
Airport diagrams are not intended to be used for approach and landing
or departure operations.
In some instances the aircraft symbol is not available for display or is
not on the chart. When this occurs, there are two annunciators that are
displayed in the chart view:
D
OWNSHIP NOT AVAILABLE -- Indicates the ownship symbol
cannot be displayed on the selected terminal procedure.
D
OWNSHIP OFF CHART -- Indicates the ownship symbol is off the
currently displayed terminal procedure.