Figure 15-74 select waypoint pop-up window, Multiple database waypoints with same identifier – BendixKing KSN 770 - Pilots Guide User Manual
Page 350
KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
15-77
Flight Management System (FMS)
Honeywell International Inc. Do not copy without express permission of Honeywell.
During the following conditions, the FROM waypoint cannot be
changed:
D
While on the ground
D
During an arc turn
D
During a radial turn
D
During a procedure turn (procedure turn as FROM).
Pushing the
ACTV
bezel softkey displays
CONFIRM ACTV
over the
desired FROM waypoint, and the
OK
and
BACK
bezel softkey
labels are displayed on the right side of the display. Pushing the
OK
bezel softkey activates the selected waypoint as the FROM waypoint.
Pushing the
BACK
bezel softkey returns to the previous display
without making any changes.
Multiple Database Waypoints With Same Identifier
When a waypoint is entered into the flight plan that has the same
identifier for multiple published waypoints, the
SELECT WAYPOINT
pop--up window is displayed, which lists all of the waypoints by name,
direct track, distance, and ETE, as shown in Figure 15--74.
Figure 15--74
Select Waypoint Pop--Up Window
The joystick knob or touchscreen is used by the pilot to selected the
intended waypoint. Pushing in the joystick knob or pushing the
OK
bezel softkey selects the waypoint. Pushing the
BACK
bezel softkey
returns to the previous display without making any changes.