BendixKing KSN 770 - Pilots Guide - Manual (Page 365)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-92
Honeywell International Inc. Do not copy without express permission of Honeywell.
Procedures (PROC)
The PROC bezel softkey label is displayed when the FMS waypoint
list window has focus or when the home window has focus on page 1/3
of the FMS bezel softkey labels. The PROC bezel softkey is used to
access departure, arrival, approach, and hold procedures. Departure,
arrival, and approach procedures are described earlier in this section.
Holding procedures are described in the following paragraphs.
When a waypoint in the flight plan (which is not the FROM waypoint)
is highlighted and the PROC bezel softkey label is active, the HOLD
bezel softkey label is displayed in 2L, as shown in Figure 15--83.
Figure 15--83
PROC Bezel Softkey Label
Holding
Three types of holding patterns exist
within the FMS. The high altitude (HA)
holding pattern terminates at a specific
altitude. The hold to a manual
termination (HM) holding pattern
requires a manual termination. The hold to a fix (HF) holding pattern
terminates when a single circuit in the hold has been completed, such
as a teardrop entry into the hold. The FMS determines the type of hold
being executed and is responsible for the proper execution of the holds.
The waypoint list displays a white HLD for all holding procedures.
NOTE: ETA for waypoints following a hold with a manual termination
are calculated based on one turn in holding then continuing
on flight plan.