BendixKing KSN 770 - Pilots Guide - Manual (Page 252)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014 12-3
Lightning Detection View
Honeywell International Inc. Do not copy without express permission of Honeywell.
The arc view mode is displayed when the ARC bezel softkey label is
active. When the arc mode is displayed, the current aircraft symbol is
located in the bottom of the strikes view, as shown in Figure 12--2.
Figure 12--2
Strikes View -- Arc
The strikes view scale is controlled using the zoom- in/+ and
zoom- out/- bezel keys , such that the outer radius of the primary
range ring represents 20 , 30 , 40 , 60 , 80 , 100 , and
200 NM from the current aircraft position. The last setting selected is
stored following the power cycle of the unit.
Strikes Display Modes
The pilot can select two strike display modes by enabling either of the
following bezel softkey labels in 2R:
D
STRK -- Activates strike mode
D
CELL -- Activates cell mode.
The display mode is indicated in the upper--right corner of the strikes
view (i.e., CELL or STRIKE ), as shown in Figure 12--2.
NOTE: The display mode annunciation is removed from display
when the FAIL NO LINK annunciation is displayed.
When strike mode is active, the displayed symbols are actual strikes.
When cell mode is active, the displayed symbols are cells, which are
a combination of strikes.