Table 12-1 lightning annunciators, Error annunciators – BendixKing KSN 770 - Pilots Guide User Manual

Page 254

Advertising
background image

KSN 765/770 Integrated Communication Navigation Display

D200802000009

REV 2 Jun 2014

12-5

Lightning Detection View

Honeywell International Inc. Do not copy without express permission of Honeywell.

Error Annunciators

Lightning symbols are removed from display

and a red horizontal line is displayed through the

strike or cell mode rate annunciator when any of

the following conditions occur:

D

The Stormscope

receiver reports a fault or error

D

The heading is invalid or unavailable

D

Lightning data is not detected

D

Position invalid (only removed from NAV MAP view).

Table 12--1 lists the possible annunciators and conditions that are

displayed in the middle of the STRIKES view when one of the conditions

are met.

Table 12--1

Lightning Annunciators

Annunciator

Condition

TEST INIT

Displayed when sensor is in

self--test mode.

TEST INIT FAIL

Displayed when a self--test report

is not received within 10 seconds.

FAIL

The sensor status is an undefined

or fatal fault.

ERROR

The sensor status is an undefined

recoverable error.

ERROR ANT ERR

The sensor status is a recoverable

antenna error.

ERROR MIC INHIBIT STUCK The sensor status is a recoverable

inhibit line stuck error.

ERROR ANT JMP CHG

The sensor status is a recoverable

antenna jumper changed error.

FAIL HDG INVALID

Heading is invalid, not available,

or not configured.

FAIL NO LINK

When configured and data is not

detected.

Advertising