BendixKing KSN 770 - Pilots Guide - Manual (Page 351)

KSN 765/770 Integrated Communication Navigation Display
D200802000009
REV 2 Jun 2014
Flight Management System (FMS)
15-78
Honeywell International Inc. Do not copy without express permission of Honeywell.
Temporary Waypoint
The TEMP WAYPOINT window is displayed when the PBD bezel
softkey is pushed (in 1L) from the following pop--up windows:
D
Direct--To
D
OBS
D
Stored Flight Plan Edit
D
Change Waypoint
D
Insert New Waypoint.
The TEMP WAYPOINT window, shown in Figure 15--75, allows the pilot
to create only temporary waypoints and does not allow the pilot to
create a waypoint for storage in the NAV database. See Creating a User
Waypoint later in this section if a custom waypoint is desired to be
created for storage in the NAV database.
Figure 15--75
TEMP WAYPOINT
The POS bezel softkey label shown in 2R allows the pilot to enter
latitude and longitude coordinates for the temporary waypoint. The
B/D bezel softkey label in 3R allows the pilot to enter a
bearing/distance from a NAV database waypoint. The position for
latitude and longitude and bearing/distance can be entered using the
joystick or touchscreen on the NAV MAP. The NRST bezel softkey in
4R displays the nearest pop--up window that the user can select the
desired FROM waypoint to be used in a temporary bearing/distance
waypoint. Pushing the OK bezel softkey enters the temporary
waypoint into the flight plan with a preceding asterisk (*).